+ Reply to Thread
Results 1 to 3 of 3

Thread: Configuring IP problem

  1. #1

    Configuring IP problem

    I am trying to set an IP on a switch interface , here is what i did :
    Switch(config)#interface fa0/1
    switch(config-if)#ip address
    And then i get an ugly error says : %Incomplete Command

  2. #2
    You are getting that error because the complete command for setting up an IP on interface is : IP-ADDRESS<Space>SUBNET-MASK .
    It should be like that :
    switch(config-if)#ip address

  3. #3
    Forgot the mask. Thanks for the help.

+ Reply to Thread

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts